Related Stories

  • Industry and Government Must Work Together to Reduce Waste
    As decisions are made concerning the prudent and proper responses to government regulatory requirements of the surface finishing industry, analysis of the total effects of each proposed responsive action prior is necessary prior to implementation. However, for such analysis to be complete, the combined knowledge bases of industry and government must be available for use.
    Members' Content
  • Non-destructive Testing for Protective Coatings: Implementing a Lifetime Corrosion Prevention Program
    During the 20th century cheap and abundant energy made corrosion a manageable problem. This era is coming to an end. Soon, industry will find there is less funding available for corrosion prevention after adjusting for rising energy costs. At this time, management will be forced to decide whether to continue with traditional corrosion control practices or change to something new with a greater potential for energy savings. For many, this will be an extremely difficult decision to make.
  • The Painful Truth About Hexavalent Chromium Permissible Exposure Limits
    A proposed government regulation designed to protect workers from exposure to hexavalent chromium carries a potentially dangerous side effect. Chrome plating employers contend the ruling would bankrupt half the industry and force other companies to relocate to countries where environmental laws are less strict.
  • Compliance Requirements of New EPA Regulations on Area Sources in the Plating and Polishing Industry
    The U.S. EPA has developed new requirements to reduce air pollution from plating and polishing facilities. Shaikh Tayeb and Tapan Das, from the Delaware Dept. of Natural Resources & Environmental Control, discuss the new compliance and reporting requirements, in addition to providing suggestions on how to cost-effectively minimize your facility's emissions. Links and downloads to helpful compliance documents are also provided.
  • Non-Destructive UV Inspection of Coatings Based on Enhanced Fluorescent Response
    The use of fluorescent materials to provide a non-destructive method for on-line inspection has been an area of increased importance to the coatings industry. Significant improvements in productivity have been realized by employing ultraviolet, UV, light curing to produce conformal coatings for computer boards.

News

OSHA Issues Inspection Procedure Guidelines on Hex-Chrome Exposure

26 February 2008

OSHA recently issued an instruction to provide guidelines and establish uniform inspection and compliance procedures for the new hexavalent chromium workplace exposure standard that was promulgated Feb. 28, 2006 (OSHA Directive Number: CPL 02-02-074).

This new directive sets forth OSHA’s policy and guidance for enforcing the hexavalent chromium workplace exposure standard. OSHA indicated that the guidance to compliance staff is necessary for effective enforcement of the applicable safety and health standards. Where the guidance directs a compliance officer to perform a specific inspection action, the compliance officer is to make every effort to perform the action, unless there is approved reason to do otherwise. OSHA does note that the guidance is meant to be a tool to ensure uniform inspection and compliance procedures, and it does not in any way affect the legal obligations of employers under the standard.

 

This article is featured in:
Environmental & Regulatory Compliance

 

Comment on this article

You must be registered and logged in to leave a comment about this article.